beautypg.com

Western Telematic SRM-100 User Manual

Page 52

background image

Register

Range

Default

Function

S38

0 - 255

20

Delay Before Forced Hang Up. This register specifies the delay (in seconds)

between the modem’s receipt of the H command to disconnect (or On-to-Off

transition of DTR if the modem is set to follow the signal), and the

disconnect operation. Applicable to error correction connection only. This

register can be used to ensure that data in the modem buffer is sent before the

modem disconnects.

S39

---

---

Bit Mapped Register.

S40

---

---

Bit Mapped Register.

S41

---

---

Bit Mapped Register.

S46

136 or

138

138

Protocol Selection. This register controls V.42bis compression.
S46=136

Disable V.42bis compression.

S46=138

Enable V.42bis compression.

S48

0, 7 or

128

7

V.42 Negotiation Action. The V.42 negotiation process determines the

capabilities of the remote modem. Note that this process is bypassed when

the capabilities of the remote modem are known and negotiation is

unnecessary.
S48=0

Disables negotiation. Bypasses the detection and negotiation

phases, and proceeds with V.42 (LAPM).

S48=7

Enables negotiation.

S48=128

Disables negotiation. Bypasses the detection and negotiation

phases, and proceeds with the fallback action specified by

register S36. Can be used to force MNP.

S82

---

---

S82 is included for compatibility purposes only. Changing this register will

have no effect.

S86

0, 4, 5, 8,

12, 13, or

14

---

Connection Failure Cause Code. When the modem issues a NO CARRIER

result code, a value is written to this S register to help determine the reason

for the failed connection. S86 records the first event that contributes to a NO

CARRIER message.
S86=0

Normal Disconnect, no error occurred.

S86=4

Loss of carrier.

S86=5

V.42 negotiation failed to detect an error correcting modem at

the other end.

S86=9

The modems could not find a common protocol.

S86=12

Normal disconnect initiated by the remote modem.

S86=13

Remote modem does not respond after 10 re-transmissions of

the same message.

S86=14

Protocol violation.

10-6

SRM-100 - Secure Rack Modem, User's Guide

S-Registers