Enabling and disabling sysstart job execution, Macintosh users, Enabling and disabling sysstart job execution 85 – Tektronix Phaser Color Printer 750 User Manual
Page 94
Advanced Features and Troubleshooting Manual
85
Troubleshooting Phaser 750 Printers
Enabling and disabling SysStart Job execution
You may load a startup (Sys/Start) file onto an optional internal IDE hard disk. The
Sys/Start job file is similar to an init file: When you turn on the printer, the file
executes — providing that Sys/Start has been enabled through a control file downloaded
to the printer.
You can also control SysStart Job execution from the printer’s front panel Printer Defaults
menu, using the Startup Mode option.
1.
Press Menu; and scroll to Configuration.
2.
Press Menu; and scroll to Startup Mode. Scroll to On and press OK; the printer
displays the following:
3.
Press
until
Ready appears.
Macintosh users
1.
From the printer’s CD-ROM, run the Installer application. Select Custom Install.
Select Printer Utilities. From your computer’s hard disk, open the PhaserTools folder.
2.
From the PhaserTools folder, double-click Apple Printer Utility.
■
Under AppleTalk Zones, select your printer’s zone.
■
Under Printers, select your printer.
■
Click Open Printer.
3.
From the Utilities menu, select Send PostScript File.
4.
From the PhaserTools folder, open the Printer Utilities folder; select SysStartJob; click
Add.
5.
Click Send.
Configuration
<---- ----> Menu
Startup Mode
<---- ----> : On
OK