Tektronix Phaser Color Printer 750 - Manual (Page 48)

Advanced Features and Troubleshooting Manual 39
Adjusting Color Density
5. After changing the density setting for any or all colors, reprint the Color Reference
Page:
■ The dashed line reflects the new settings.
■ In this example, the density for each color is set to a different value.
This table shows the selections available in the Calibrate Colors menu.
Calibrate Colors menu selections
Menu item* What it does How it works
Adjust light/dark
<---- ----> Menu Lightens or darkens all toner colors.
For best results adjust each color
individually in the Adjust each color
menu. ■ Press Menu.
Lighter/Darker:+0 *
<---- ----> OK
Lightens or darkens all toner colors.
The current Light/Dark setting reflects
the average value of the four separate
density settings. Each increase adjusts
all four density values up or down the
same amount. The available
adjustment range is limited so that no
single color exceeds the ±10 value
limit.
■ To lighten colors, press
<-- (the number
decreases in 1-point
steps); then press OK.
■ To darken colors, press
--> (the number
increases in 1-point
steps); then press OK.
Adjust each color
<---- ----> Menu Controls the color density for each
color independently. ■ Press Menu.
Color Reference Page
<---- ----> Print Prints a sample of the current density
settings and a range of settings for each
color. ■ Press Print.
Cyan Magenta Yellow Black
-9
-7
-5
-3
-1
+1
+3
+5
+7
-6
-4
-2
0
+2
+4
+6
+8
+10
-9
-7
-5
-3
-1
+1
+3
+5
+7
+9
Color Reference Page
9698-18.color
-4
-2
0
+2
+4
+6
+8
+10