Tektronix Phaser 350 - Manual (Page 179)

Caring for Your Printer 5
User Manual 5-39
Moving Your Printer
Waiting 30 minutes before moving
Before you move the printer, you’ll want to wait for the printer to display the
Ready message or the printer’s network name, then turn off the printer
using the rear-panel On/Off switch.
Caution To avoid damaging the printer, let the printer cool down for at
least 30 minutes before you move it so that the ink has time to
solidify. Failure to wait 30 minutes will likely result in an ink
spill that will damage the printer’s internal components.
Removing the maintenance tray
1. Remove the maintenance tray from the printer, keeping it level.
Remove, empty, and replace the waste tray. Refer to “Emptying
the waste tray” on page 5-4 for detailed instructions.
2. Place the maintenance tray in a plastic bag and seal the bag.
The maintenance tray contains drum fluid that leaks if the tray is
tipped. Keep the maintenance tray level and in a sealed plastic
bag while transporting it.
Caution To avoid damaging your printer and invalidating your
printer’s warranty, remove the maintenance tray before
moving the printer. Always store a used maintenance tray in a
leak-proof package. When handling the maintenance tray, keep
it level. Never ship a partially used maintenance tray. Contact
with the drum fluid poses no known health risk. Refer to
“MSDS for silicone oil” on page 9-6 for more information.