TANDBERG Gatekeeper - Manual (Page 84)

TANDBERG Gatekeeper User Guide
Page 84 of 105
16.3. Command
The command root command,
xcommand
, is used to execute commands on the Gatekeeper.
To list all
xcommand
s type:
xcommand ?
To get usage information for a specific command, type:
xcommand <command_name> ?
16.3.1. AllowListAdd
xCommand AllowListAdd <allowed_alias>
Adds an entry to the allow list, used by the registration restriction policy.
allowed_alias
can either be a specific alias, or use the wildcards
?
(for a single character) and
*
(for a single character or string of characters) to pattern match a group of possible aliases.
16.3.2. AllowListDelete
xCommand AllowListDelete
Removes the pattern with the specified index from the allow list.
Allow list entries can be viewed using the command
xconfiguration Gatekeeper
Registration AllowList
.
16.3.3. Boot
xCommand Boot
Reboots the Gatekeeper. This takes approximately 2 minutes to complete.
16.3.4. CallTransfer
xCommand CallTransfer Call: Leg: <1/2> Alias:
Attempts to transfer the half of the call identified by the call index and leg to the given alias.
Call and leg indices may be identified using
xstatus calls
.
16.3.5. CheckBandwidth
xCommand CheckBandwidth
This is a diagnostic function for verifying bandwidth control.
Node1
Node2
The case-sensitive names of the nodes.
bandwidth
The required bandwidth.
calltype
Must be one of
Traversal
,
Routed
or
Direct
16.3.6. CredentialAdd
xCommand CredentialAdd <username> <password>
Adds the given username and password to the local authentication database.