TANDBERG Gatekeeper - Manual (Page 18)

TANDBERG Gatekeeper User Guide
Page 18 of 105
You will be presented with the Overview screen:
Note: HTTP and HTTPS must be enabled in order to use the web interface. This is done using the
following commands:
xConfiguration HTTP Mode:
xconfiguration HTTPS Mode:
Note: If web access is required, you are recommended to enable HTTPS and disable HTTP for improved
security.
4.2.2. Command line interface
The command line interface is available over SSH, Telnet and through the serial port.
To use the command line interface, start a session and login with user name admin and your password.
The interface groups information in different commands:
xstatus
Provides a read only interface to determine the current status of the system. Information such as current
calls and registrations is available through this command group.
xconfiguration
A read/write interface to set system configuration data such as IP address and subnet.
xcommand
A miscellaneous group of commands for setting information or obtaining it.
xhistory
Provides historical information about calls and registrations.
xfeedback
An event interface, providing information about calls and registrations.
See the Command Reference (section 16) for a full list of commands.