TANDBERG Gatekeeper - Manual (Page 82)

TANDBERG Gatekeeper User Guide
Page 82 of 105
xconfiguration Zones TraversalZone Match [1..5] Mode:
The zone match mode determines when an LRQ will be sent to gatekeepers in the zone. If the mode is
set to
AlwaysMatch
the zone will always be queried. If the mode is set to
PatternMatch
, the zone
will only be queried if the alias queried for matches the corresponding pattern. If the mode is set to
Disabled
the zone will never be queried.
xconfiguration Zones TraversalZone Match [1..5] Pattern String: <pattern>
The pattern to be used when deciding whether or not to query a zone. This is only used if the zone's
match mode is set to
AlwaysMatch
.
xconfiguration Zones TraversalZone Match [1..5] Pattern Type:
Prefix/Suffix
determines whether the pattern string being checked should appear at the beginning
or end of an alias. Alternatively,
Regex
indicates that the pattern string should be treated as a regular
expression when matching.
xconfiguration Zones TraversalZone Match [1..5] Pattern Behavior:
Determines whether the matched part of the alias should be modified before an LRQ is sent to the
indicated zone. If set to
Leave
, the alias will be unmodified. If set to
Strip
, the matching prefix or
suffix will removed from the alias. If set to
Replace
, the matching part of the alias will be substituted
for the replace text. Note that
Strip
is not a supported option if the pattern type is set to
Regex
.
xconfiguration Zones TraversalZone [1..100] Match [1..5] Pattern Replace:
The string to be used as a substitution for the part of the alias that matched the pattern.
xconfiguration Zones Zone [1..100] Name: <name>
Sets an administrator-specified name for the zone.
xconfiguration Zones Zone [1..100] Gatekeeper [1..6] Address: <IPAddress>
Specifies the IP addresses of the gatekeepers in the zone. Multiple addresses allows support for
alternate gatekeepers.
xconfiguration Zones Zone [1..100] Gatekeeper [1..6] Port: <port>
Specifies the port on which the indexed gatekeeper is listening for RAS messages.
xconfiguration Zones Zone [1..100] HopCount: <count>
Specifies the hop count to be used when originating an LRQ.
xconfiguration Zones Zone [1..100] Monitor:
If zone monitoring is enabled, an LRQ will be periodically sent to the zone gatekeeper. If it fails to
respond, that gatekeeper will be marked as inactive.
xconfiguration Zones Zone [1..100] Match [1..5] Mode:
The zone match mode determines when an LRQ will be sent to gatekeepers in the zone. If the mode is
set to
AlwaysMatch
the zone will always be queried. If the mode is set to
PatternMatch
, the zone
will only be queried if the alias queried for matches the corresponding pattern. If the mode is set to
Disabled
the zone will never be queried.