TANDBERG Gatekeeper - Manual (Page 73)

TANDBERG Gatekeeper User Guide
Page 73 of 105
xconfiguration Authentication Mode:
Specifies whether or not to use H.235 authentication of calls and registrations. The default is
Off
: no
authentication is required.
16.2.2. Ethernet
xconfiguration Ethernet Speed:
Sets the speed of the Ethernet link. Use
Auto
to automatically configure the speed. The default is
Auto
.
You must restart the system for changes to take effect.
Note: to find out the current speed, use
xstatus Ethernet Speed
.
16.2.3. ExternalManager
xconfiguration ExternalManager Address:
Sets the IP address of the External Manager. The External Manager is the remote system, such as the
TANDBERG Management Suite (TMS), used to manage endpoints and network infrastructure.
xconfiguration ExternalManager Path:
Sets the URL of the External Manager.
16.2.4. Gatekeeper
Commands under the
Gatekeeper
node control aspects of the system's operation as an H.323
gatekeeper.
xconfiguration Gatekeeper Alternates Monitor:
Controls whether or not alternate gatekeepers are periodically interrogated to ensure that they are still
functioning. In order to prevent delays during call setup, non-functional alternates will not receive
Location Requests .
xconfiguration Gatekeeper Alternates Alternate [1..5] Address:
<IPAddress>
Sets the IP address of an alternate Gatekeeper. Up to 5 alternates may be configured. When the
Gatekeeper receives a Location Request, all alternates will also be queried.
xconfiguration Gatekeeper Alternates Alternate [1..5] Port: <Port>
Sets the IP port of an alternate Gatekeeper. The default is
1719
.
xconfiguration Gatekeeper AutoDiscovery:
Specifies whether or not the Gatekeeper responds to gatekeeper discovery requests from endpoints.
The default is
On
.
xconfiguration Gatekeeper CallRouted:
Specifies whether the Gatekeeper should operate in call routed mode. The defaults is
Off
.