Tektronix K1297-G20 - Manual (Page 47)

Getting Started
K1297-G20 Monitor User Manual 35
Connecting to the Data Line
The Protocol Tester can be connected to the data line in the on or off state
using the cables available as accessories.
1. Plug the right plug on the one end of the cable into a socket of the
measuring module. In the K1297 they are located on the rear of the
device. In the K1297 Compact the sockets of the measuring modules
are located underneath the cover of the Protocol Tester.
The individual cables available as accessories are listed in the data
sheet. Or ask your local sales partner about them.
We recommend that the cable length be less than 3 m.
You can control the individual measuring modules and the interfaces
(sockets) via the K1297-G20 Monitor application.
CAUTION. Please pay attention to possible impedance differences. The
Protocol Tester is set to high impedance as default. For low input
impedance you must set the tester accordingly. This is done via the
K1297-G20 Monitor application.