Tektronix K1297-G20 User Manual
Page 187
Appendix D: Windows XPe Troubleshooting
K1297-G20 Monitor User Manual
E-9
Repair the K1297 by Recovery Disk.
To repair the K1297 by the recovery disk,
proceed as follows:
CAUTION. Make sure that the protocol tester and the external CD-RW drive
are both powered off!
1. Attach the SCSI cable of the CD-RW drive to the SCSI I/O BUS
connector of the instrument. The SCSI connector is located on the front
of the K1297 compact and on the rear of the K1297.
2. Turn on the CD-RW drive .
3. Insert the CD ROM labeled “K1297, Recovery CD (Build XPe)” into
the CD-RW drive.
4. Switch on the device. Press , when the initial BIOS screen
appears. This opens the BIOS Setup dialog.
5. Use the arrow keys to select the option “BIOS FEATURES SETUP”
and press
6. In the dialog that opens, verify the settings of the “Boot Sequence”
option. If the sequence A,C,SCSI is currently not selected, change it
using the
7. Press
8. Press