Telos ZephyrExpress - Manual (Page 60)

Z EPHYR E XPRESS HARDWARE 3-19
Power Input
PIN Voltage
1 +5Vdc @ 5A
2 +12Vdc @ 1.5A
3 -12Vdc @ .5A
4 System Ground
A separate modular power supply is provided with ZephyrExpress. Make sure it is not
turned on, or check to make sure it isn’t connected to an AC line. Then plug its 4-pin XLR
connector into the jack on the right side of the rear panel.
The supply is self adjusting between 100 - 250 VAC, 50-60Hz. Power consumption is 150
Watts. The supply is cooled by convection through slots in the case; make sure these
aren’t blocked during use. It is normal for the case to become warm during use.
The input connector is a standard IEC, used on electronic equipment and most
computers.
Power Supply XLR Output
PIN Wire Color* Voltage
1 Black +5Vdc @ 5A
2 Yellow +12Vdc @ 1.5A
3 White -12Vdc @ .5A
4 Blue + Red System Ground
*Color codes correspond to power supply model HES61-30
Power Supply