Telos ZephyrExpress - Manual (Page 25)

QUICK RESULTS 1-13
Tap the EDIT knob to hang up. Now you’re ready to really rock!
Tune into one of our test lines
Our US test line originates less than a mile from the Rock ‘n’ Roll Hall of Fame, in
Cleveland, Ohio. There’s always something interesting playing through it.
We also maintain a European test line in Freising, Germany.
Here’s how to connect to them:
d
Press the DIAL button.
A screen like this will appear:
U
If the word Auto is not highlighted, turn the EDIT knob until it is.
With Auto highlighted, tap the knob towards the panel to confirm. The screen will
change like this:
Turn the knob to select US testline* or Euro testline* . The asterisk means the number
is pre-programmed at the factory. Tap the knob to confirm.
After you tap, the highlighting will switch to the Go! box. Tap again to dial.
If ZephyrExpress’ codec is not already set to the correct mode to receive the testline, the
unit will automatically change to match. This may take a few seconds.
Then ZephyrExpress will dial the test line. In a few seconds, you should see the red LOCK
LEDs light, and music on the RECEIVE meters. If you see the words Busy or Conn once or
twice on the status screen, try again later.
p
When you’re finished talking to yourself via ISDN, press the DROP button.
The screen will change to look like this: