Telos ZephyrExpress - Manual (Page 112)

MENUS 6-17
— Panic dial Lets you choose a dialing setup to be activated when pin 7 of the par-
allel remote control is pulled to ground. Pin 7 must be held to ground
until you want to drop the call.
h
HOT TIP!
It’s not just for panics. You can use the Panic Dial feature for automatic backup
of a satellite or alternative ISDN system by connecting it to that system’s Lock
output. Or connect it to a timer for automatic activation at repeating unsuper-
vised events (such as daily press conferences or meetings), or to an SPST switch
for one-touch access to the studio.
— ISDN Setups See Setups, page 6-6
System menu
The first item in this menu is the System Setup. See page 6-6.
— Contrast Adjusts the LCD display’s contrast for different viewing angles
— Backlight Adjusts the LCD display’s backlighting
h
ADJUSTING A BLANK SCREEN
If someone has left the Contrast or Backlight at a position where the screen is
invisible, you’ll have a hard time finding these menu items to reset them.
To reset contrast from any screen, press DIAL and hold that button in while you
turn EDIT .
To reset backlighting from any screen, press DROP and hold it in while you turn
EDIT .
— Click Volume Adjusts the volume of all of ZephyrExpress’ button and menu re-
sponse sounds. Can be set to 0 for quiet operation.
— POTS volume Adjusts the volume of the internal speaker when ZephyrExpress is
connected to an analog call. Can be used as an alert for incoming
calls
1 , or set to 0 for quiet operation.
— Menu timeout Sets the length of inactivity before ZephyrExpress reverts to the next
higher-level menu. The timer starts again at the higher menu, and
will keep reverting until it reaches the Status screen.
1 You might need the alert because ZephyrExpress picks up on the first ring... so there
won’t be a long ringing sound.