Telos ZephyrExpress - Manual (Page 102)

MENUS 6-7
Select the Action field and choose from Create new , Update , Activate , View, or Delete .
Then confirm.
If you’re creating a new setup, you’ll then be able to enter a name using the keypad. After
you confirm the name, the
Go! box will be selected. Press EDIT again to confirm, and all
the current settings for this menu will be stored with that name.
If you’re updating an existing setup, the Name field will display the existing setups for
this menu. Select one and the
Go! box will be selected. Press EDIT again, and — after a
confirmation screen — all the values for this setup will be changed to match the current
menu settings. You can’t update a setup that was programmed at the factor (indicated by
an asterisk in its name).
If you’re Deleting a setup, select it the same way. When you confirm Go! , you’ll see the
message Do you really want to delete this setup? Select Yes and confirm. You can’t
delete a setup that’s used in a Master setup (below); delete or change that Master setup
first. You also can’t delete a setup that was preset at the factory.
You can also use Activate to apply a setupfrom this screen, but it’s faster to use the setup
item at the top of the menu.
Master Setups
Master Setup
Menus
The top item in the Utility screen is the Master setup It works like individual menu setups,
but can change all the menus at once. You can use factory-supplied Master setups or cre-
ate your own.
h
HOT TIP!
Master setups don’t have to change every menu, so you can create your own for
particular kinds of remotes — say,
Talkshow or News Event or Concert — that
modify just the Audio and Codec menus without affecting the ISDN setups for a
venue.
Applying a Master Setup
Highlight the top line of the Utility screen and press EDIT to select it. Then turn EDIT to
scroll through the possible Master setups. The currently-applied setup will have brackets
around its name. Be sure to turn
EDIT in both directions: there may be setups on both
sides of the current one.