Telos ZephyrExpress - Manual (Page 51)

3-10 Z EPHYR E XPRESS HARDWARE
Used to enter numbers for dialing, and text for setup names. Dialing works like a
telephone.
To enter text characters, press the key with the appropriate letter printed on it. Keep
tapping it to cycle through the possible choices. For example, tapping the
2 -key in a text
field will first enter A . Repeated taps will change that to a B , then C , then the lower-case
letters, then the number 2 . Enter a space by pressing 1 three times. Punctuation characters
appear on the * and # keys.
For example:
Press the number 2 once ..... See the character A
... press it again ..... See the character B
... press it again ..... See the character C
... press it again ..... See the character a
... press it again ..... See the character b
... press it again ..... See the character c
... press it again ..... See the numeral 2
... press it yet again..... the cycle starts again from A
To move to the next character in a field, tap any other key or turn the EDIT knob
clockwise. To back up, turn the knob counter-clockwise.
i
ISDN TIP!
ISDN doesn’t use DTMF “Touch-tones”, even for calls to standard analog phones,
so the keypad doesn’t generate these sounds. If you need those tones to control
a remote device, get an accessory tone generator at an electronics store and
either pick up its signal with a microphone, or modify the generator for line-
level output.
Rear Panel
From ISDN
NT-1 Adapter
SAFE
switch
From ISDN
direct line
Line sync indicator
NOTE: You only need
to use one of these:
Monitor 1 outputs
Direct ISDN
receive outputs
Monitor 2
output
Remote and Download Mic Inputs
Parallel Control
Line Inputs
XLR or 1/4” from
Power Supply
Note: This picture shows the back of a ZephyrExpress intended for sale in North
America. Units shipped elsewhere will have only the upper NT1 phone jack, and no Line
Sync indicator.