Telos ZephyrExpress - Manual (Page 36)

1-24 QUICK RESULTS
you can reach the right average level but peaks are too loud, make sure the limiter is
turned on.
To test the digital compression engine, verify in the Status Screen that both transmit and
receive are set to the same coding method (use
L3-Stereo as a generic receiver when
transmitting with L3-Dual , L3-Stereo , or L3-Joint ). If necessary, change the methods
using the Codec submenu. Then scroll down the Codec submenu to Loop Mode, and set
the mode to Near . After a few seconds, both LOCK LEDs should light. Turn off the
Monitor 2 SEND routing switch, and set the Monitor 2 Receive routing switch to A B. Now,
any audio you send should be heard in the headphones, after a slight coding delay.
Don’t forget to set Loop Mode back to Off before connecting to the studio.
ISDN Connection
15: How do I place a call?
d
1. Tap the DIAL button. A screen like this will appear:
2. Select Manual , Auto , or Recent . Auto lets you select pre-programmed setups; Recent
lets you automatically redial numbers you’ve entered manually.
If you select Auto , a screen like this will appear:
Choose a setup from the top of the screen. When you tap, the Go! box will be selected. Tap
again to dial that number. If any menu setups were preprogrammed with that Autodial setup,
ZephyrExpress will apply them before placing the call. This may change the coding method,
audio setups, or even ISDN setup and system behavior depending on how it was
programmed.
If you select Manual or Recent , a screen similar to this will appear:
Select a recently-called number or enter a number from the keypad. If you’re entering
manually, don’t forget to add any codes or “1” required in your dialing area. If you make a
mistake, turn the knob counter-clockwise to back up.