beautypg.com

Monitor mixers – Telos ZephyrExpress User Manual

Page 45

background image

3-4

Z

EPHYR

E

XPRESS HARDWARE

h

HOT TIP!

If you need line inputs with separate gain or routing controls, you can convert
either or both microphones to line level: set the

Audio: Microphone

Sensitivity

adjustments to

line +1 dB.

Level Controls

The three large knobs, with black caps, control the send level for their respective inputs.

MIC 1

and

MIC 2

are mono controls;

LINE 1&2

is a stereo control.

There are two of these: one for each of the two stereo monitor circuits. Press to cycle
between

A

,

B

,

A B

, and off. This determines which of the two

SEND

signals — the ones

mixed by the large black knobs, and showing on the upper VU meters — will be sent to
each monitor. Each of the two send signals is mono; you can adjust how they’re panned
in the monitors by using the

Audio: Monitor1 XMT

and

Monitor 2 XMT

submenus.

h

HOT TIP!

Our monitor panning system is very sophisticated and its submenus might not
be immediately intuitive. There’s a full explanation of how they work in the next
section of this manual.

Receive Routing Switches

Again, there are two: one of each of the two stereo monitor circuits. Press to cycle
between

A

,

B

,

A B

, and off. These determine which of the two signals received via ISDN —

the signals displayed on the lower VU meters — will be sent to each monitor. Each
received signal is mono; you can adjust how they’re panned in these monitors by using
the

Audio: Monitor1 XMT

and

Monitor 2 XMT

submenus.

Level Controls

These determine how much of the send and receive signal will be applied to each of the
two stereo monitor circuits. Monitor 1’s knobs have gray caps, matching the gray rings
around the

MON 1

headphone and XLR output jacks on the rear panel. Monitor 2’s knobs

have white caps, matching the white rings around the

MON 2

headphone jacks on the

front and rear panel.

Monitor Mixers

Send Routing Switches