Toshiba B-850 - Manual (Page 92)

APPENDIX 4 SYSTEM MODE EO1-33029
A4.5 Test Print
A4-16
A4.5 Test Print (Cont.) Issue Mode Selection
Select the issue mode for the test print by selecting between “[S]NO
CUT” (Batch mode without cut) and “[C]WITH CUT” (Cut mode).
After selecting the Issue Mode, press the [PAUSE] key to go to Label
Length Setting.
Label Length Setting
Select the label length for the test print in a range from 5 mm to 999 mm.
[FEED]
key: Pressing the [FEED] key one time causes a –1 mm change,
up to 5 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a +1
mm change, up to 999 mm.
After selecting the label length, press the [PAUSE] key to go to Paper
Feed Selection.
Paper Feed Selection
Select whether or not a paper feed is performed.
After selecting the paper feed, press the [PAUSE] key. The display
returns to the “<4>TEST PRINT”.
7<3(>6@12&87
7<3(>&@:,7+&87
7<3(>6@12&87
[RESTART]
[FEED]
Batch mode
without cut
Cut mode
[RESTART]
[FEED]
/$%(//(1PP
/$%(//(1PP
/$%(//(1PP
3$3(5)(('
3$3(512)(('
3$3(5)(('
[RESTART]
[FEED]
Paper feed is
available.
Paper feed is not
available.
NOTE:
Cut mode is available only when
the optional cutter module (B-
7208-QM) is installed. When
you need the cutter, please
contact your nearest TOSHIBA
TEC service representative.
NOTE:
Press and hold the [RESTART]
or [FEED] key to advance the
values quickly and continuously.
To stop it, release the key.
NOTE:
When “PAPER FEED” is
selected, the printer feeds the
media prior to a test print to
adjust the print start position.
When “PAPER NO FEED” is
selected, the printer starts
printing without a print start
position adjustment. If the
print start position adjustment
is unnecessary, Select "PAPER
NO FEED" and save media.