Toshiba B-850 - Manual (Page 21)

2. PRINTER SETUP EO1-33029
2.7 Loading the Media
2-11
2.7.3 Loading Media into the
Printer (Cont.)
10. After loading the media, don’t forget to move the Supply Holder
Unit to the forward notches of the Supply Roll Frame as shown
below.
11.
If you are using labels or thick tag paper, then it may be necessary to
increase the head pressure by lowering the Head Pressure Adjust
Lever in the figure below.
Head Pressure Adjust Lever
Forward Notch
NOTE: Head Pressure Adjust Lever Position
Lever position Head pressure Available media
UP Low
•
Thin tag paper
•
Narrow media
DOWN High
•
Label
•
Thick tag paper
•
Wide media
•
Full width media
•
When using full width media, be sure to turn the Head Pressure Adjust
Lever to DOWN, regardless of the thickness.
•
For all kinds of media except the full width media, turn the Head Pressure
Adjust Lever to UP, if the print quality is to be ensured.
•
If the print tone is light when using thin tag paper, turn the Head Pressure
Adjust Lever to DOWN.
UP
DOWN