beautypg.com

11 test print (cont.) – Toshiba B-850 User Manual

Page 26

background image

2. PRINTER SETUP

EO1-33029

2.11 Test Print

2-16

2.11 Test Print (cont.)


















8.

Press the

[PAUSE]

key again and the printer will now print five

labels of sample bar codes lines and the LCD Message Display will
continue to display the following message.



9.

Press the

[PAUSE]

key again and the printer will now print five

labels of characters of various sizes and the LCD Message Display
will return to showing the test print start message as shown below.



10.

Upon pressing the

[RESTART]

key for the second time in step

6

,

the LCD Message Display will change to that shown below.



11.

Press the

[PAUSE]

key and the printer will issue one blank label

and will then print five labels of slant lines and the LCD Message
Display will continue to display the following message.



12.

Press the

[PAUSE]

key again and the printer will now print five

labels of sample bar codes lines and the LCD Message Display will
continue to display the following message.



13.

Press the

[PAUSE]

key again and the printer will now print five

labels of characters of various sizes and the LCD Message Display
will return to showing the test print start message as shown below.



14.

If necessary, the print test may now be repeated from step

4

.

15.

When you have finished performing the test print operation, turn the
printer’s power OFF then back to ON and check that the LCD
Message Display shows

ON LINE

and that the

ON LINE

and

POWER

LED lights are illuminated.

NOTE:

If an error occurs during the
print test the printer will
display an error message and
stop printing. Refer to Chapter

6.1 for a definition of error
messages.

The error may be cleared by
pressing the

[PAUSE]

key but

the test print will not be
resumed and the LCD message
display will return to showing:

<1> DIAG. V1.0A

$87235,175()/

!7(6735,17

$87235,1775$1

$87235,1775$1

$87235,1775$1

!7(6735,17

NOTE:

When the

[PAUSE]

key is

pressed in Step 10, the printer
will enter each print pattern
detailed on the setting menu
mode. To exit, press the

[FEED]

and

[RESTART]

keys

at the same time.