Toshiba B-850 - Manual (Page 104)

APPENDIX 4 SYSTEM MODE EO1-33029
A4.7 Additional Information
A4-28
A4.7.2 Maintenance Counter/Parameter Check Print Sample and Descriptions (Cont.)
•
Descriptions of the Maintenance Counter
No. Item Count Condition Range
(1) Total media distance covered 0.0 to 2000.0 km
(2) Media distance covered
Counted when the feed motor is driven to
feed, print and issue the media. (Counted
also during ribbon saving operation and
back feed.) See NOTE 6 and 7.
0.0 to 181.9 km
(3) Print distance
Counted while printing. (Feeding and back
feed are not counted.) See NOTE 2.
0.0 to 200.0 km
(4) Cut count Counts every cut. [See NOTE 3.] 0 to 1000000 times
(5) Ribbon motor driving time
Counts when the ribbon motor is driven to
feed, print and issue the media. (The
driving time is not counted during ribbon
saving operation, but is during back feed.)
0 to 2000 hours
(6)
RS-232C hardware error
count Counted when a parity, overrun or framing
error occurs. See NOTE 5.
0 to 255 times
(7) System error count Counted when any error occurs. 0 to 15 times
(8)
Momentary power failure
count Counts the number of times the power
restores while the CPU is busy after reset.
0 to 15 times
•
Descriptions of the Parameters
No. Item Contents
(9) Feed length fine adjustment (PC), (KEY) -50.0 mm to +50.0 mm
(10) Cut position fine adjustment (PC), (KEY) -50.0 mm to +50.0 mm
(11) Back feed length fine adjustment (PC), (KEY) -9.9 mm to +9.9 mm
(12)
Print tone fine adjustment (Thermal transfer), (PC),
(KEY)
-10 step to +10 step
(13)
Print tone fine adjustment (Thermal direct), (PC),
(KEY)
-10 step to +10 step
(14)
Ribbon rewind motor driving voltage fine adjustment
(PC), (KEY)
-15 step to +0 step
(15)
Ribbon feed motor driving voltage fine adjustment
(PC), (KEY)
-15 step to +10 step
(16) X axis fine adjustment -99.5 mm to +99.5 mm
(17)
Threshold manual fine adjustment for the black mark
sensor
0.0V to 4.0V
(18)
Threshold manual fine adjustment for the feed gap
sensor
0.0V to 4.0V
NOTES:
1. Item from (2) through (10) are initialized to “0” after RAM clear.
2. If the Print distance is 5.5m or less, it is rounded down and no data is added to the memory at power off.
3. If the count is 31 counts or less, it is rounded down and no data is added to the memory at power off.
4. If the driving time is 27 sec. or less, it is rounded down and no data is added to the memory at power off.
5. When a sent command results in an error, the same number as the data capacity of the command is counted
by byte.
6. If the media distance covered is 69.4 cm or less, it is rounded down and no data is added to the memory at
power off.
7. When the media distance covered reached to the maximum, the maintenance counter should be cleared.
Otherwise, the total media distance covered will not be updated. For the maintenance counter clear, please
contact your nearest TOSHIBA TEC service representative.