Toshiba B-850 - Manual (Page 79)

APPENDIX 4 SYSTEM MODE EO1-33029
A4.3 Self-Diagnostic Test
A4- 3
A4.3 Self-Diagnostic
Test The Self-Diagnostic Test contains the following sub menus:
While pressing the
[FEED] and [PAUSE] keys at the same time, turn
on the printer. Hold both keys until the “<1>DIAG.” Message appears
in the display.
Printing mode selection
Press the
[PAUSE] key. The type of printing mode can be selected:
“TRANSFR” (Thermal transfer) or “DIRECT” (Thermal direct).
After selecting the printing mode to be used, press the
[PAUSE] key.
Maintenance counter/parameter settings print out
The printer is ready to print out the Maintenance Counter/Parameter
Settings. Press the
[PAUSE] key to start.
The printer starts printing out the Maintenance Counter/Parameter
Settings.
After printing is completed, the display returns to “<1>DIAG. Vx.x”.
!',$*9[[
3577<3(75$16)5
0$,17(1$1&( &217
&+(&.,1* 35,17
NOTE:
When using the ribbon, be sure
to select “Thermal Transfer”.
When using thermal media, be
sure to select “Thermal Direct”.
NOTE:
See Section A4.7.1 for the
Maintenance
Counter/Parameter Settings
print sample and detailed
descriptions for each.
[PAUSE]
[PAUSE]
[FEED]
[FEED]
[RESTART]
[RESTART]
[FEED]
Selection of the printing mode.
Prints out the Maintenance
Counter /Parameter Settings.
Performs a Self-Diagnostic Test,
and prints out the result.
Checks to see if there is any
problem with the print head.
Outline of Self-Diagnostic Test
In the Self-Diagnostic Test
mode,
,the printer checks and
prints out the printer system
information such as the sensor
or interface, and the
Maintenance Counter.
It also
performs the print head broken
element check.
3577<3(',5(&7
Thermal transfer
Thermal direct
[RESTART]
[FEED]
NOTE:
Use the [FEED] or
[RESTART] key to select a
desired option.
NOTE:
“x.x” of “DIAG. Vx.x”
indicates firmware version and
i i
!',$*9[[
$872',$*1267,&
0$,17(1$1&(&217
+($'&+(&.
3577<3(75$16)5
[RESTART]