Toshiba B-850 - Manual (Page 73)

APPENDIX 1 SPECIFICATIONS EO1-33029
A1.4 Ribbon
A1- 5
A1.4 Ribbon
Please make sure that the ribbon being used is approved by TOSHIBA TEC. The warranty does not apply to any
problem caused by using non-approved ribbons.
For information regarding TOSHIBA TEC approved ribbon, please contact a sales representative.
Type Spool type
Width 120 – 220 mm
Recommended width is 120, 160 and 220 mm.
Length 300 m
Outside Diameter
φ
72 mm (max.)
The table below shows the correlation between ribbon width and media width (backing paper is not included).
Ribbon width Media width
120 mm 100 – 110 mm
160 mm 110 – 150 mm
220 mm 150 – 242 mm
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified ribbons.
2. To avoid ribbon wrinkles use a ribbon which is wider than the media by 10 mm or more. However, too
much difference in width between the two may cause wrinkles.