Toshiba B-850 - Manual (Page 70)

APPENDIX 1 SPECIFICATIONS EO1-33029
A1.2 Options
A1- 2
A1.2 Options
Option Name Type Description Source
Cutter module B-7208-QM A stop and cut swing cutter. See NOTE.
PCL5 interface board B-7708-PCL-QM This board enables the B-852 printer to support the
HP-PCL5. See NOTE.
Expansion I/O
interface board B-8700-IO-QM Installing this board in the printer will allow a
connection with an external device with the
exclusive interface, such as the keyboard module.
See NOTE.
Keyboard module KB-80-QM This module is an external intelligent keyboard unit,
including a 16 digit by 2 line LCD and 28 key
switches. See NOTE.
PCMCIA interface
board B-7708-PC-QM This board enables the use of the following
PCMCIA cards:
LAN card: 3 COM EtherLink® III (recommended)
ATA card: Conforming to PC card ATA standard
Flash memory card: 4MB card (See page 2-14.) See NOTE.
A1.3 Media
Please make sure that the media that will be used is approved by TOSHIBA TEC. The warranty does not apply
when a problem is caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC-approved media, please contact a TOSHIBA TEC authorized service
representative.
A1.3.1 Media Type
Two types of media can be loaded for this thermal transfer/direct thermal printer-label or tag. The table below
shows size and shape of the media available for this printer.
NOTE:
Available from your nearest TOSHIBA TEC representative or TOSHIBA TEC Head Quarters.
Label
c
d
f
e
h
i
j
Tag paper
c
e
g
h
i
Cut position
Cut position
Stop
position
Stop
position
Feed Direction
Black Mark
(on reverse side)
Black Mark
(on reverse side) Refer to
NOTE 3 below.