Toshiba B-850 User Manual

Page 101

APPENDIX 4 SYSTEM MODE

EO1-33029

A4.7 Additional Information

A4-25

A4.7.1 Self-Diagnostic Test Result Sample and Descriptions (Cont.)

(8) Sensor 1 Check

The status of the Cutter Home Position Sensor, Ribbon Feed Motor Sensor, and Ribbon Rewind Motor
Sensor are printed.

SENSOR1 0 0 0 0 0 0 0 0 , 0 1 1 1 0 0 1 1

Sensor/Switch

Print status content description

Cutter home position switch

Indicates whether or not the cutter is at the home
position.

Ribbon rewind motor sensor 1
Ribbon feed motor sensors 1 and 2

Controls ribbon motor rotation by detecting the slit on
the ribbon rewind motor and the ribbon feed motor.
Indicates the position of the slit sensor.

(9) Sensor 2 Check

The status of the Print Head Thermistor, Environmental Temperature Thermistor, Heat Sink Thermistor,
Black Mark Sensor (Upper/Lower), and Feed Gap Sensor are printed.

SENSOR2

[H]20

C [A]22

C [S]25

C [R(U)]3.3V [R(L)]4.0V [T]2.4V

Fixed to 1.

Cutter home position switch status
0: Home position
1: Other position

Fixed to 1.

Fixed to 0.

Ribbon rewind motor sensor 1 status
0: The detecting point is positioned outside the slit.
1: The detecting point is positioned inside the slit.

Fixed to 0.

Ribbon feed motor sensor 1status
0: The detecting point is positioned outside the slit.
1: The detecting point is positioned inside the slit.

Fixed to 0.

Ribbon feed motor sensor 2 status
0: The detecting point is positioned

outside the slit.

1: The detection point is positioned

inside the slit.

Feed gap sensor status:
0.0 – 5.0V

Heat sink thermistor status:
25

C, 80

C, 90

Black mark sensor (Lower) status:
0.0 – 5.0V

Black mark sensor (Upper) status:
0.0 – 5.0V

Print head thermistor status:
0

C - 86

Environmental thermistor status:
0 - 86

If it is undetectable, “--

C “ is printed.