V display current configuration, W store current configuration, Zn=x store telephone number – Toshiba A40 Series User Manual
Page 242
User's Manual
C-10
A
PPENDIX
C
&T0
Abort. Stops any test in progress.
&T1
Local analog loop. This test verifies modem operation, as well
as the connection between the modem and computer. Any
data entered at the local DTE is modulated, then demodulated,
and returned to the local DTE. To work properly, the modem
must be off-line.
Result Codes:
OK
n=0
CONNECT
n=1
ERROR
Otherwise
&V
Display Current Configuration
This command displays the current configuration of the modem. If
nonvolatile memory is supported the stored profiles are displayed
as well.
&V
View profiles.
&W
Store current configuration
Saves the current (active) configuration (profile), including S-Regis-
ters.
The current configuration comprises a list of storable parameters
illustrated in the &V command. These settings are restored to the
active configuration upon receiving a Zn command or at power up.
Refer to the &V command.
&W
Stores the current configuration.
&Zn=x
Store telephone number
This command is used to store up to four dialing strings in the
modem’s nonvolatile memory for later dialing. The format for the
command is &Zn=“stored number” where n is the location 0-3 to which
the number should be written. The dial string may contain up to 34
characters. The ATDS=n command dials using the string stored in
location n.
Result codes:
OK
n=0, 1, 2, 3
ERROR
Otherwise