Onkyo TX-NR1000 - Manual (Page 80)

80
Enjoying Net Audio —Continued
The music server settings can be made while you select
the music server as an input source.
Configuring the Music Server
1 Press the [INPUT] button, and
then roll the scroll wheel to select
MSRV.
Make sure that the “MSRV” is displayed
when you configure the music server.
2 Press the scroll wheel, and then
press the [SETUP] button to dis-
play the Main Menu.
3 Use the [ ]/[ ] buttons to select
“Input Setup,” then press the
[ENTER] button.
--/---
@. - ' / ABC DEF
PQRS TUV WXYZ
DIRECT TUNING
GHI JKL MNO
CUSTOM
DISPLAY
DIMMER
T V
INPUT
SLEEP
MUTING
ENTER
ON STANDBY
TV
TV CH
TV VOL
SE RVE R AUDIO
AD J
EXIT
GU ID E
PREV
CH
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
INPUT
TO P M ENU MEN U
SET UP
RE TURN
ZONE 2
INPUT MODE
MACRO
VOL CH
DISC
+
-
+
-
I
ZONE 3
#
INPUT
SETUP
ENTER,
/ / /
Scroll wheel
INPUT
ENTER
ENTER
4 Use the [ ]/[ ] buttons to select
the “Music Server” sub-menu,
then press the [ENTER] button.
The setup screen for the sub-menu
appears.
5 Use the [ ] and [ ] cursor but-
tons to select “Select Server” and
then use the [
] and [ ] cursor
buttons to select the desired
server.
Select a network server that exists on the
network.
* mark appears next to the servers
detected on the network. If there is a
server that does not have a * mark, make
sure that the server is running. “Not
Found” message indicates that no server
is currently available for selection. If the
message appears, make sure that the
server is connected and running.
6 Press the [SETUP] button.
This completes the configuration proce-
dure and the menu disappears.
Tips:
When choosing settings on the
TX-NR1000/TX-NR5000E, after select-
ing the input source using the input source
buttons, press the [SETUP] button. Next,
select the menu you want to configure by
turning the [SELECT/PRESET] dial and
press the dial to confirm the selection.
Then, after selecting the submenu you
want to configure by turning the
[SELECT/PRESET] dial, select your
value by turning the [CONTROL/TUN-
ING] dial, and press the dial to confirm
the value. If you want to go back to the
previous operation, press the [EXIT] but-
ton.
ENTER
ENTER
ENTER