Onkyo TX-NR1000 - Manual (Page 63)

63
Listening to RDS Broadcasts (European models only) —Continued
If the station you are currently tuned into is broadcasting
RT signals, they will be displayed in the front display on
the TX-NR5000E. If the station does not, this function
will be ignored.
• If the current station you are listening to is not an RDS
station, only the frequency of the station will appear.
• If “Waiting” appears on the display, more time is
required to receive the RT information. When the
information is received, the characters will scroll
across the front display.
• If “No Text Data” appears on the display, RT informa-
tion is not available.
• The display shows the frequency for 3 seconds and
returns to program service name.
Displaying Radio Text (RT)
To display the radio text, press the
[RT/PTY/TP] button once.
Performing a PTY Scan
1 Press the [TUNER] input source
button and select the FM input
source.
2 Press the [RT/PTY/TP] button
twice.
The current program type appears on the
display.
3 Using the [SELECT/PRESET] dial,
select the PTY program type you
desire.
OFF ON
STANDBY/ON
STANDBY
PURE AUDIO
MASTER VOLUME
POWER
OPEN ZONE 2 ( ) GREEN MAIN ( ) BLUE REC / ZONE 3 ( ) RED DISPLAY
DVD VIDEO 3 VIDEO 4 VIDEO 5 VIDEO 6 VIDEO 7 VIDEO 2 VIDEO 1
MEMORY
SETUP
EXIT
PHONES
VIDEO 7 INPUT S VIDEO DIGITAL AUDIO VIDEO L R
LISTENING MODE AUDIO SELECTOR TONE
CLEAR
RT/ PTY/ TP
ZONE 2 REC/ ZONE 3
LEVEL LEVEL
SELECT/ PRESET CONTROL / TUNING
PUSH TO ENTER PUSH TO ENTER
C D NET AUDIO PHONO TUNER TAPE 1 TAPE 2
TUNING MODE
SELECT/PRESET
TUNER
RT/PTY/TP
RT/PTY/TP
TUNER
RT/PTY/TP
SELECT/PRESET
4 Press the [SELECT/PRESET] dial.
The TX-NR5000E will scan until it
reaches a station of the program type you
selected. It will then stop briefly at that
station before continuing on until it
reaches the next station. Pressing the
[SELECT/PRESET] dial stops the PTY
scan at that point. If you press the [RT/
PTY/TP] while “NONE” is displayed,
“PTY ?” will appear. In this case, return
to step 3.
5 Press the [SELECT/PRESET] dial
when it reaches the station that
you want to listen to.
“Not Found” will appear when no RDS
signal is being received from the station.
Performing a TP Scan
1 Press the [TUNER] input source
button.
2 Press the [RT/PTY/TP] button
three times.
“[TP]” will appear if the current station
is broadcasting TP signals. This station
will periodically broadcast traffic infor-
mation. To find a different station, pro-
ceed to the next step. Also, if “TP” is
displayed, proceed to the next step.
3 Press the [SELECT/PRESET] dial.
The TX-NR5000E will scan until it
reaches a station broadcasting traffic
information. If “Not Found” appears on
the display, a TP station cannot be
located.
SELECT/PRESET
SELECT/PRESET
TUNER
RT/PTY/TP
SELECT/PRESET