Onkyo TX-NR1000 - Manual (Page 122)

122
Network Setup —Continued
While the system sending information is called a server,
the machine receiving the data is called a “client.”
Multiple clients can be connected to a single server.
From the viewpoint of Net-Tune Central, the
TX-NR1000/TX-NR5000E is a client.
a. Client Name
Confirm the client name used on the Net-Tune system.
The client name is assigned by the TX-NR1000/
TX-NR5000E. You cannot change the assigned name.
b. Wakeup on LAN
Specify the network condition on standby of the
TX-NR1000/TX-NR5000E.
Enable: To be left connected.
Disable: To be disconnected while the TX-NR1000/
TX-NR5000E is on standby to save electricity.
c. NTSP Port
Specify the TCP/IP port to communicate with Net-Tune
Central. This setting is to determine the port for
intercommunication and needs to match the setting at
Net-Tune Central. Do not change the port number
unless absolutely necessary. Press the [
]/[ ]/[ ]/
[ ] buttons to select numerics, and then press the
[ENTER] button. When all numerics are entered, exit
from the character entry mode.
Note:
When the settings are complete, press the [RETURN]
button to return to the Network Setup menu. Use the
[
]/[ ] buttons to select “ → Save Settings,” and then
press the [ ] button to save settings described in
“Network Setup” on pages 121 and 122. After setting,
saving data will take a few seconds. While saving data,
be sure not to turn off the power, otherwise the data will
be lost.
Specifications:
Ethernet port: 10BASE-T
File type: MP3, WMA, WAV
(supports non-compression format and sampling
frequency of 32 , 44.1, 48 kHz)
(WMA files with contents protected cannot be played)
Client Sub-menu