Onkyo TX-NR1000 - Manual (Page 53)

53
Connecting the Power/Basic Operations —Continued
Using the Sleep Timer (remote controller only)
With the sleep timer you can set the TX-NR1000/
TX-NR5000E so that it automatically turns off after a
set period.
Temporarily Changing the Speaker Output
Levels (remote controller only)
To change the individual speaker volumes temporarily,
follow the procedure given below. Each channel can be
set between –12 and +12 decibels (between –15 and
+12 decibels for the subwoofer). Note that the speaker
volumes will return to the original settings when the
TX-NR1000/TX-NR5000E is put in the standby state.
Note:
You cannot select a speaker if it is set to “Not Used” in
the Speaker Configuration Sub-menu of the Speaker/
Output Setup Menu.
Press the scroll wheel, and then
press the [SLEEP] button repeat-
edly to select the required sleep
time.
You can set the sleep time from 90 to 10
minutes in 10 minute increments.
The [SLEEP] indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about five
seconds, then the previous display
reappears.
Note:
If you are using the remote zone (Zone 2
or 3), it will turn off at the same time as
the main zone.
To cancel the sleep timer, press the
[SLEEP] button repeatedly until the
[SLEEP] indicator disappears.
To check the remaining sleep time,
press the [SLEEP] button. Note that if
you press the [SLEEP] button while the
sleep time is being displayed, you’ll
shorten the sleep time by 10 minutes.
CAPS DELETE LANGUAGE LOCATION
ALBUM AR TIST GENRE PLAYLIST
REPEAT VIDEO MUSIC PHOTO
DISPLAY
DIMMER
T V
INPUT
SLEEP
RANDOM REC MAIN A MAIN B
MUTING
ENTER
LAST M ANGLE SUBTITLE AUDIO
MEMORY SEARCH A-B REPEAT
SE RVE R AUDIO
AD J
EXIT GU ID E
PREV CH
TO P M ENU MEN U
SET UP RE TURN
ZONE 2
INPUT MODE
MACRO
VOL CH
DISC
TEST TONE CH SEL
PURE A
SURR
DIRECT
STEREO
Re-EQ
THX ALL ST
LEVEL+ LEVEL-
L NIGHT AUDIO SEL
DSP DSP
+
-
CH SEL LEVEL–
LEVEL+
SLEEP
Scroll wheel
RC-557M
RC-558M
SLEEP
Remote
controller
1 Press the scroll wheel to enter the
AMP mode.
2 Press the [CH SEL] button and
select the desired speaker.
3 Press the [LEVEL –] or [LEVEL +]
button to adjust the volume level.
CH SEL
LEVEL+ LEVEL-