Onkyo TX-NR1000 - Manual (Page 69)

69
Enjoying Movies and Music in the
Remote Zone (Zone 2/3)
—
Continued
Recording a Source
The TX-NR1000/TX-NR5000E can not only record the
playing source but can also record a source while play-
ing another source. You can also combine a video and
audio to create a new source.
Signals that can be output to a video/audio recording
device vary with the type of jack connected. Check the
following conditions before starting recording:
Audio
• Signals (analog) from the ETHERNET, PH, or
AUDIO IN jacks are output only to the AUDIO OUT
jacks. Music signals of MP3, WMA, and WAVE to be
played with Net-Audio are also output only to analog
audio output jacks.
• No signal is output from the MULTI-CH IN jacks.
• No signal is output from the HDMI IN jacks. Record-
ing via the HDMI OUT jack is also disabled because
Rec Out is not available in Audio Output Assign.
• Signals from the DIGITAL IN OPTICAL or COAX-
IAL jacks are output to the DIGITAL OUT OPTI-
CAL or COAXIAL jacks. PCM signals are converted
into analog signals, and also output to the AUDIO
OUT jacks.
• Only PCM signals are output from the i.LINK
(AUDIO) terminals to the AUDIO OUT jacks. Digital
signals are output from the i.LINK (AUDIO) termi-
nals to the DIGITAL OUT OPTICAL or COAXIAL
jacks, but signals on Super Audio CD and DVD-
Audio are not output.
Video
• Video signals from the VIDEO IN, S VIDEO IN, or
COMPONENT VIDEO IN jack are output only to the
VIDEO OUT jacks.
• When not using Zone 2 or Zone 3, press the
[ZONE 2] (or [REC/ZONE 3]) button, and
then press the [STANDBY/ON] button. Or
press the [ZONE 2] (or [REC/ZONE 3]) but-
ton, and then turn the [SELECT/PRESET] dial
to select “Off.” In the case of Zone 2, the green
indicator on the input source button is turned
off, and in the case of Zone 3, the red indicator
is turned off.
• When operating in the main room, be sure to
confirm that the [STANDBY] indicator is not
blinking, and then start operations. When not
using in the main room, press the [STANDBY/
ON] button. If the TX-NR1000/TX-NR5000E
is in the standby status, the power supply to
Zone 2 and Zone 3 is not switched off.