Raymarine Marine GPS System - Manual (Page 143)

RayTech Navigator User’s Guide
5-52
Polar Parameters Screen
To enter data into the Polar Parameters screen, do the following:
1. On the Polars screen, click the Polar tab. The Polar
Parameters screen is displayed (Figure 5-14).
Figure 5-14. Polar Parameters Screen
2. Replace as much of the default data as possible with real data
that you’ve collected. You can modify the default values
shown, or you can load an existing Polar Parameters file. To
modify the values shown, skip to Step 4. To load an existing
Polar Parameters file, click
Open . The open file dialog box
is displayed.
3. Choose the Polar Parameters file (.rpl extension) you want,
then click Open . The selected file is displayed.
Loaded Polar Parameters filename appears here
Click on any cell to edit its value Click Apply to plot new variables after editing
Click
Open to load Polar Parameters
Click
Save/Save As to
save changes to file