Ricoh 3245 - Manual (Page 80)

Using Internet Fax Functions
72
3
Sending by IP-Fax
IP-Fax function uses TCP/IP (LAN or
Internet), and the same procedures as
the standard fax function. Functions
available in both standard and IP-Fax
transmission can be used in generally
same manner.
By connecting your machine to a
gateway (T.38-compliant) or gate-
keeper, you can send to a standard G3
facsimile connected to the public
switched telephone network (PSTN)
via TCP/IP.
Preparation
Make the necessary System Set-
tings beforehand. See “Network
Guide.”
Note
❒ If you have set “Enable H.323” and
“Enable SIP” parameters to “On”
with “IP-Fax Settings” under “Fac-
simile Features”, [Protocol] ap-
pears. Press this button to select a
protocol to be used.
❒ To send via the Internet, the receiv-
er’s machine must also be connect-
ed to the Internet. You cannot send
to a firewall-protected network.
❒ For a list of gateways (T.38-compli-
ant) or gatekeepers that are certi-
fied as operable with this machine,
contact your local reseller or ser-
vice provider.
❒ When using the transfer request
function, you can specify the IP-
Fax destination to the transfer sta-
tion. See p.88 “Sending the Trans-
f e r R es u lt R ep o rt ” , F a cs i m ile
Reference .
❒ When under Sender Settings E-
mail TX Results is set to “Yes” and
IP-fax transmission is specified, a
transmission result notification
mail is sent to the destination. See
p.81 “Communication Result Re-
port (Memory Transmission)”,
Facsimile Reference tures> .
AAAA
Press to switch the destina-
tion to IP-Fax number.
BBBB
Specify the IP-Fax destination of
the receiver.
Reference
p.37 “Entering an IP-Fax Desti-
nation”
p.40 “Using Destination Lists”
p.47 “Redial”, Facsimile Refer-
ence
JupterC2_Fax_EN-F_FM.book Page 72 Tuesday, November 30, 2004 2:47 PM