Ricoh 3245 - Manual (Page 30)

Faxing
22
2
- - - -Checking the transmission
settings
You can check the transmission set-
tings (e.g. destination and transmis-
sion mode) on the display.
A Press the
{{{{Check Modes}}}} key.
The following display appears.
Note
❒ Pressing switches the des-
tination list between fax num-
ber, e-mail address, and IP-Fax
number.
B After checking the settings on the
display, press the
{{{{Check Modes}}}}
key.
The display before the
{{{{Check
Modes
}}}} key was pressed appears.
- - - -Broadcasting Sequence
If you dial several destinations for the
same message (broadcasting), the
messages are sent in the order in
which they were dialed. If the fax
message could not be transmitted, the
machine redials that destination after
the last destination specified for
broadcasting. For example, if you
specify four destinations, A through
D, for broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
See p.79 “Simultaneous Broadcast”,
Facsimile Reference tures>
- - - -Checking the transmission
progress
To check the transmission progress,
print the TX file list. See p.25 “Print-
ing a List of Files in Memory (Print TX
File List)”, Facsimile Reference vanced Features> .
ZLBS040N
JupterC2_Fax_EN-F_FM.book Page 22 Tuesday, November 30, 2004 2:47 PM