Roland RG-1 - Manual (Page 99)

97
* Please refer to “Leaflet For a Dealer or a Qualified Professional Installer (RG-1).”
* You will also need to have a Phillips screwdriver.
1. Remove the four caps attached to the rear leg.
To remove a cap, grasp it, then pull it out while twisting it
counterclockwise.
2.
Using screws “a” (M8 x 20 mm), provisionally attach the left
and right brackets in the holes exposed by detaching the caps,
and adjust the brackets so that they are firmly in contact with
the floor.
3. After adjusting the brackets, tighten screws “a” to fasten the
left and right brackets in place securely.
Installing the Brackets
R
Caps
L
Caps
Screws “a”
(M8 x 20 mm)
Screws “a”
(M8 x 20 mm)
RG-1_e.book 97 ページ ２００８年４月８日 火曜日 午後２時３６分