Roland RG-1 - Manual (Page 81)

79
Connecting External Devices
You can connect audio devices to play the sound of the RG-1
through the speakers of your audio system, or to record your
performance on a tape recorder or other recording device.
Use phone plug audio cables (sold separately) to make
connections.
* When connection cables with resistors are used, the volume
level of equipment connected to the input jacks may be low. If
this happens, use connection cables that do not contain
resistors.
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
1. Turn the volume all the way down on the RG-1
and on the speakers you’re about to connect.
2. Turn off the power to the RG-1 and the speakers.
3. Use audio cables (sold separately) to make the
connection.
4. Switch on the RG-1.
5. Switch on the connected speakers.
6. Adjust the volume level on the RG-1 and the
connected speakers.
When you play the RG-1’s keyboard, the sound is played
from the RG-1’s and connected speakers.
Turning Off the Power
1. Turn the volume all the way down on the RG-1
and on the connected speakers.
2. Turn off the connected speakers.
3. Turn off the RG-1.
Connecting to Audio Equipment
Connecting Speakers to the RG-1 and Outputting Sounds
Amplified Speakers,
Audio System, etc.
RG-1_e.book 79 ページ ２００８年４月８日 火曜日 午後２時３６分