Roland RG-1 - Manual (Page 75)

73
Changing Various Settings
When connecting a MIDI sequencer, set Local Control to
“OFF.” The setting is at “Local Control ON” when the RG-1
is powered up.
Since the Thru function of your sequencer will normally be
turned on, notes played on the keyboard or played back by
the recorder will be transmitted to the sound generator by
the two routes (1) and (2) shown in the illustration, causing
notes to be sounded in duplicate or to be cut off unnaturally.
To prevent this, the setting called “Local Off” is used to
disconnect the route in (1).
fig.07-130
Local On:
The keyboard and recorder are connected to the internal
sound generator.
fig.07-140
Local Off:
The keyboard and recorder are not connected to the
internal sound generator.
No sound will be produced by the keyboard and
recorder when it is played.
fig.07-150
→ When connecting a unit in the Roland MT series, you don’t
need to switch off Local Control. MT units transmit Local Off
messages when their power is switched on. If you first switch
on the RG-1, then the MT-series device, Local Control is
automatically switched off on the RG-1.
1. Press the [Function] (Exit) button, getting its
indicator to light.
2. Press the [Song] (Select -) button or [ ] (Select
+) button to display the MIDI screen.
fig.07-110d
3. Press the [Song] (Select -) button or [ ] (Select
+) button to get the value for “Local” (Local
Control) to flash.
fig.07-151d
4. Press the [ ] (Value -) button or [ ] (Value
+) button to switch Local Control on or off.
5. Press the [Function] (Exit) button so the indicator
goes out.
Preventing Doubled Notes When
Connected to a Sequencer (Local Control)
(1)
MIDI
MIDI MIDI
MIDI
(2)
IN
IN OUT
OUT
Sequencer
Memory
Sound
Generator
Each note played is sounded twice
Soft Thru On
Local On
Local On
Sound is emitted
Sound Generator
Local Off
No sound produced
Sound Generator
Value Description
On Local Control is switched on.
Off Local Control is switched off.
RG-1_e.book 73 ページ ２００８年４月８日 火曜日 午後２時３６分