Roland TD-6V - Manual (Page 89)

89
Chapter 5 Editing Songs (SONG Edit)
5
Adjusting the Stereo Position (Pan)
Adjusts the pan (the perceived location of the sound between
the left and right speakers).
The effect set here applies only when connected in stereo.
Percussion parts do not feature the Pan setting.
fig.05-027_50
Pan: L15–Center–R15
L15: Sound is positioned at the extreme left.
CENTER: Sound is positioned in the center.
R15: Sound is positioned at the extreme right.
Adjusting the Amount of Ambience
(Ambience Send Level)
You can adjust the ambience level for each part individually.
The ambience effect deepens the higher the value is set. When
set to “0,” no ambience is applied.
The specified ambience effect is applied to the currently
selected drum kit. To check how the effect sounds, select a
drum kit that has the Ambience Switch set to “ON.” (KIT/
AMBIENCE/Ambience SW; p. 60)
fig.05-028_50
AmbSendLevel: 0–127
Adjusting the Bend Range
(Bend Range)
This adjusts the degree to which the pitch of the sound is
changed when the maximum Pitch Bend is received from an
external MIDI device.
This can be set from “0” to “24” (two octaves) in semitone
steps. When set to “0,” no change is made.
Percussion parts do not feature the Bend range setting.
fig.05-029_50
Bend Range: 0–24
Copying a Song (COPY)
This is used to copy Preset songs and User songs to other User
songs.
Part instruments and volume and other settings are copied
just as they are.
Executing this operation deletes the content of the copy
destination, so check all content carefully before carrying out
this operation.
1. Confirm that [CLICK] is not lit.
If this lights, press [CLICK] to extinguish it.
2. Press [SONG], then [EDIT].
[SONG] and [EDIT] light.
3. Press [ ] to select “COPY.”
fig.SONG-COPY_50
4. Press [ENTER ].
5. Press [ ] or [ ] to select the copy source
song.
fig.05-030ai.e
6. Press [ ].
The copy destination song selection screen appears.
Copy source song
TD-6KV_e.book 89 ページ ２００５年１月２４日 月曜日 午後７時４分