Roland TD-6V - Manual (Page 101)

101
Chapter 7 Making the MIDI Settings (SETUP/MIDI, BULK DUMP)
7
Set the Device ID (Device ID)
The setting described here is necessary only when you wish to
transmit separate data to two or more TD-6V units at the same
time. Do not change this setting in any other case.
At the factory settings, the device ID is set to “17.”
Example:
When saving data using Bulk Dump (p. 103), save using “17”
as the TD-6V Device ID. When re-transmitting this data back
to the TD-6V, it won’t receive if the Device ID is set to
something other than “17.” Even if you happen to have
another TD-6V connected, data will not be received if the
Device ID is set to something other than “17.”
fig.07-018.e (ID 16 17)
If you lose track of the Device ID setting that was used when
saving data via a bulk dump, it will no longer be possible to
reload the bulk data that was saved.
fig.07-019_50
Device ID: 1–32
Setting the TD-6V So That Program
Changes Are Not Transmitted (Tx PC Sw)
The TD-6V sends a Program Change message to external
devices when the drums kit is switched. If this is “OFF”,
Program Changes will not be transmitted.
The TD-6V’s drum kit program numbers are always the same
as the drum kit numbers; this relationship is fixed, and cannot
be changed.
The settings screen does not appear in GM mode.
fig.07-020_50
Tx PC Sw (Tx PC Switch): OFF, ON
OFF:
Program Change messages are not transmitted, even when
drums kits are switched.
ON:
Program Change messages are transmitted when drum kits
are switched.
Setting the TD-6V So That Program
Changes Are Not Received (Rx PC Sw)
The TD-6V’s drum kits are switched when a Program Change
message is received from an external MIDI device. When set
to “OFF,” the drum kits do not switch, even when a Program
Change message is received.
The TD-6V’s drum kit program numbers are always the same
as the drum kit numbers; this relationship is fixed, and cannot
be changed.
The settings screen does not appear in GM mode.
fig.07-021_50
Rx PC Sw (Rx PC Switch): OFF, ON
OFF:
The drum kits are not switched, even when Program Change
messages are received from an external MIDI device.
TD-6V
Device ID: 17
Not Received
MIDI IN MIDI OUT
Transmit Data (Device ID:17)
TD-6V
Device ID: 16
MIDI IN
External MIDI Sequencer
TD-6KV_e.book 101 ページ ２００５年１月２４日 月曜日 午後７時４分