Roland TD-6V - Manual (Page 111)

111
Troubleshooting
Appendices
No sounds from pads connected to
Trigger Inputs 6 (AUX) and 8
(TOM4)
Have you made correct trigger settings?
(SETUP/TRIG TYPE; p. 69)
➝ Change the settings if you are connecting two pads to
Trigger Inputs 5/6 (TOM2/AUX) and 7/8 (TOM3/4).
Cannot Make Cross Sticks/
Cross Sticks Not Sounding
Do you have a pad connected to a trigger
input that is capable of handling cross sticks?
(p. 33)
➝ When using the PD-80R, PD-85, PD-105, PD-120 or PD-125
to play cross sticks, connect to Trigger Input 2 (SNARE).
Has the instrument that can be used for
playing the cross sticks been selected?
(KIT/INST; p. 58, Drum Instrument List; p. 120)
➝ Use the instrument with the “XS.”
Are you playing the cross stick correctly?
(p. 36)
➝ For cross stick, make sure your hand or stick does not
touch or strike the head.
No Sound When the Pad is Struck
Softly
Did you strike a pad or press the pedal at any
time from when the TD-6V’s power was
turned on until the kit name appeared in the
display?
➝ Using the procedure of p. 23, turn the power on once again
without playing any pads or pedals during the TD-6V’s
warm up.
Precautions When Turning On the Power
When the TD-6V is turned on, it carries out a check of the
pads. If you strike a pad or press the pedal anytime during
this process, the pads cannot be checked properly,
resulting in incorrect functioning of the pads.
Volume levels for the rims of TOM2
and TOM3 not changing
Have you made the appropriate settings for
AUX or TOM4?
(SETUP/TRIG TYPE; p. 69)
➝ To use the TOM2 and TOM3 rims, set the AUX and TOM4
trigger types to "Rim."
No Sound When [SHIFT] + [KIT]
(Preview) Is Pressed
Is the [PREVIEW] button velocity set to “0?”
(SETUP/UTILITY/Preview Velo; p. 78)
➝ Press [+] or [-] to make the setting.
No Click/Metronome Sound
Does [CLICK] light? (p. 79)
➝ Press [CLICK] to light the button.
Is the click volume level set to “0?”
(CLICK/Click Level; p. 79)
➝ Press [+] or [-] to make the setting.
Song Does Not Play
Is GM Mode set to “ON?”
(SETUP/MIDI COMMON/GM Mode; p. 99)
➝ Press [+] or [-] to set this to “OFF.” The sequencer does not
function when the TD-6V is in GM mode.
TD-6KV_e.book 111 ページ ２００５年１月２４日 月曜日 午後７時４分