Roland TD-6V - Manual (Page 66)

66
Chapter 1 Creating Your Own Drum Kit (Kit Edit)
Overall Drum Kit Settings
(COMMON)
Make the settings for each drum kit.
1. Confirm that [CLICK] is not lit.
If this lights, press [CLICK] to extinguish it.
2. Press [KIT], then [EDIT].
[KIT] and [EDIT] light.
3. Press [ ] to select “COMMON.”
fig.KIT-CMN_50
4. Press [ENTER ].
5. Press [ ] or [ ] to select the parameter you
wish to edit.
fig.01-046ai.e
6. Press [+] or [-] to make the setting.
fig.01-047ai.e
7. When you finish making settings, press [KIT] to
end the procedure.
Overall Drum Kit Volume
(Master Volume)
You can adjust the overall volume of the drum kit while
preserving the volume balance between each of the pads. The
higher the value is set, the greater the volume. With a setting
of “0,” no sound is produced.
The volume balance among the pads is adjusted in the “Level”
(KIT/INST/Level; p. 59).
fig.01-048_50
MasterVolume (Master Volume): 0–127
Adjusting the Volume of the Pedal
Hi-Hat Sound (Pedal Hi-Hat Volume)
For each drum kit, you can adjust the volume of the pedal hi-
hat that sound (when the hi-hat control pedal is pressed). The
higher the value is set, the greater the volume. With a setting
of “0,” no sound is produced.
Set the volume level of other pads with the “Level” setting
(KIT/INST/Level; p. 59).
fig.01-049_50 (KIT-COMMON-Pedal-Hat)
Pedal HH Vol (Pedal Hi-Hat Volume): 0–15
Setting the Range for the Pitch
Control with the Hi-Hat Control
Pedal (Pedal Pitch Control Range)
Pitch Control is a function that lets you change the pitch of an
instrument assigned to a pad according to the amount the hi-
hat control pedal is pressed.
Releasing the pedal returns the instrument to its original pitch.
The degree to which the pitch is to change when the hi-hat
control pedal is pressed is set in semitone (half-step)
increments from -24 (down two octaves) to +24 (up two
octaves). When set to “0,” there is no change in pitch.
Pitch Control is turned on and off in the “Pitch Ctrl (Pitch
Control)” setting (KIT/CONTROL/Pitch Ctrl; p. 64).
• To prevent the pedal hi-hat sound from being played
when the hi-hat pedal is pressed, set “Pedal HH Vol
(Pedal Hi-Hat Volume)” to “0” (KIT/COMMON/Pedal
HH Vol; p. 66).
• To have changes in pitch occur smoothly, set
“PdlDataThin (Pedal Data Thin)” to “1” or “OFF”
(SETUP/MIDI COMMON/PdlDataThin; p. 99).
fig.01-050_50
PchCtrlRange (Pedal Pitch Control Range):
-24–+24
Parameter to set
Value
TD-6KV_e.book 66 ページ ２００５年１月２４日 月曜日 午後７時４分