Roland TD-6V - Manual (Page 23)

23
Setup Guide
Turning On/Off the Power
941
Once the connections have been completed (p. 22), turn on power to your
various devices in the order specified. By turning on devices in the wrong order,
you risk causing malfunction and/or damage to speakers and other devices.
fig.P-001
1
Turn the [VOLUME] knob completely to the left to lower the volume to
the minimum level.
2
Turn down the volume control on the connected amp or audio system.
3
Press the [POWER] button to turn on the power.
1, 5 3
5
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
If the hi-hat control pedal
is pressed when the power
is turned on, control of the
hi-hat’s opening and
closing will not work
correctly. Striking the pads
when turning on the
power degrades the pad
response when the pads
are struck lightly.
Precautions When Turning on the Power
After the power is turned on, the drum kit name (shown in the
following figure) appears in the display; do NOT press any pad
or pedal until [KIT] has lighted.
fig.P-002ai
TD-6KV_e.book 23 ページ ２００５年１月２４日 月曜日 午後７時４分