RAD Data comm TDMoIP Gateway IPmux-16 - Manual (Page 65)

IPmux-16 Installation and Operation Manual Chapter 3 Operation
Configuring IPmux-16 3-33
Time Slots Configuration
1. Slot/Channel 3/1
2. Bundle Number 1
3. Time slot number 1-1
4. Time slot Current Status SET
ESC. Exit
ACTIVE TIME SLOTS IN THIS BUNDLE:
FREE TIME SLOTS: 1,2,3,4,5,6,7,8,9,10,11,12,13,14,15,
17,18,19,20,21,22,23,24,25,26,27,28,29,30,31
Select item from the menu.
Figure 3-31. Time Slots Configuration Menu
➤ To configure IPmux-16 bundles:
1. Type 1 to select the slot and channel to be configured.
2. Type 2 to select the bundle to be configured.
3. Type 3 to select the timeslot to be assigned to the previously chosen bundle.
4. To set timeslot(s) change the desired timeslot status to "set" and type S to save
the change. IPmux-16 will associate the new timeslot with the chosen bundle.
5. To free a time slot from the bundle, change the desired timeslot status to "free"
and type S to save the change. IPmux-16 will free the time slot from the
current bundle.
You cannot change the bundle timeslot(s) if the channel is active. (First disable the
channel via "Bundle Connection Configuration.")
In Bundle Connection Configuration: Deactivate the connection first.
In T1 configuration: Valid timeslots are 1–24.
In E1 configuration: Timeslot 0 is always invalid and timeslot 16 is not valid for
Fractional with CAS.
A list of assigned timeslots (active timeslots in this bundle) and free timeslots on this
link is shown at the bottom of the menu screen.
If the selected channel is configured to work in Unframed mode (physical), it will be
attached to bundle number XXX and Bundle Number and Time
Slot Number will not be available on the menu and the
following message will appear:
!!This port is in unframed mode!!
Note