RAD Data comm TDMoIP Gateway IPmux-16 - Manual (Page 25)

IPmux-16 Installation and Operation Manual Chapter 1 Introduction
Technical Specifications 1-17
T1
Framing Compliance
Framing
Signaling ANSI T1.403
Passthrough, SF, ESF
CAS (bit robbing), CCS (transparent)
Local
Terminal
and
Control
Interface
Mode
Baud Rate
Connector RS-232 over RJ-45 (adapter cable to DB-15 supplied)
DTE
9.6, 19.2, 38.4, 57.6, 115.2 kbps
DB-9
Dry
Contact
Alarm
Connector
Contacts DB-9
30V 2A
Ethernet
Modules Compliance
Connector
Ports
Data Rate
Range IEEE 802.3, 802.3u, Ethernet, 802.1 p&q
RJ-45, 8 pin
1
10 Mbps or 100 Mbps, full or half duplex
Up to 100m over UTP Category 5 cables
General System Indicators
General:
PS1 Green ON when main power supply is
OK
OFF when malfunction is
detected, power does not exist or
power is off.
PS2 Green ON when secondary power
supply is OK
OFF when secondary power
supply does not exist (no power
supply redundancy) or when
power is off
RDY Green ON when self-test is successfully
completed
OFF during self-test
BLINKS when self-test fails
ALM Red: ON when a Minor alarm is
detected
OFF when no alarms are
detected