RAD Data comm TDMoIP Gateway IPmux-16 - Manual (Page 56)

Chapter 3 Operation IPmux-16 Installation and Operation Manual
3-24 Configuring IPmux-16
Physical Layer Configuration
Main Menu
↓
2. Configuration
↓
2. Physical Layer
Configuration
➤ To configure the IPmux-16 physical layer:
• Type 2 (Physical Layer Configuration) in the Configuration menu.
PHYSICAL LAYER CONFIGURATION
1. Slot #1 – ETHERNET >
2. Slot #2 - NO CARD
3. Slot #3 – 4E1/T1 >
4. Slot #4 – 8E1/T1 >
ESC. Exit
Figure 3-26. Physical Layer Configuration Menu
LAN Configuration
Main Menu
↓
2. Configuration
↓
2. Physical Layer
Configuration
↓
1. LAN Physical
Layer
Configuration
➤ To view and configure LAN port type:
• Type 1 to access your Ethernet card (LAN Physical Layer Configuration) in
the Physical Layer Configuration menu.
LAN PHYSICAL LAYER CONFIGURATION
1. Auto Negotiation Enable
2. Max Capability advertised 100baseT Full Duplex
3. Default type 100baseT Full Duplex
ESC. Exit
Select item from the menu.
Figure 3-27. LAN Physical Layer Configuration Menu
➤ To enable or disable the auto-negotiation mode:
• Type 1.
Use the spacebar on your keyboard to toggle between Enable and Disable.
(Autonegotiation mode is according to RFC 2239.)