RAD Data comm TDMoIP Gateway IPmux-16 - Manual (Page 36)

Chapter 3 Operation IPmux-16 Installation and Operation Manual
3-4 Getting Started
➤
To set all passwords to the default value (xxxxxxxxxx ):
1. Enter su for User Name.
2. Delete the unit’s configuration through the Configuration screens.
Deleting the unit’s configuration using <Cntl+A> and choosing 4 in the Boot
Menu does not set the passwords to the default value.
➤ If a user forgets his password:
• Consult Technical Support at RAD for further assistance (send email to
[email protected]).
Turning IPmux-16 Off
➤ To power off the unit:
1. If you are using a terminal connection, press escape until you return to the
main menu and press 4. Exit.
2. Switch PS1 (and PS2 if connected) to OFF.
3.4 Getting Started
After installation, there are no special operating procedures for IPmux-16. Once it
is powered up, the unit operates automatically. Proper operation is indicated by
the front-panel LED indicators (Figure 3-1 and Figure 3-2). The unit operational
status can be monitored constantly.
If required, the IPmux-16 can be reconfigured. Both the IPmux-16 configuration
and monitoring operations are performed locally from an ASCII terminal, Telnet or
NMS connected to the Control Port. Detailed configuration procedures are given
later in this chapter. The following functions are supported:
• View system information
• Modify configuration and mode of operation, including setting system default
values
• View statistics and status
• Perform diagnostics.
IPmux-16 configuration and system monitoring, including troubleshooting
procedures, can also be performed from a remote site using a Telnet application or
RADview (RAD’s HP OpenView based SNMP).
Telnet and the local terminal cannot work simultaneously. Note
Note