Renesas Emulator System E8 - Manual (Page 39)

3.5 Connecting the Emulator to the Host Computer
This section describes how to connect the emulator to the host computer. For the position of each
connector of the emulator, refer to section 3.2, Emulator Hardware Configuration.
Notes: 1. When [Add New Hardware Wizard] is displayed, select the [Search for the best driver
for your device. (Recommended)] radio button and then the [Specify a location] check
box to select the path to be searched for drivers. The location must be specified as
:\DRIVERS. ( is the CD drive name.)
2. Be sure to install the emulator’s debugger before putting the emulator in place.
WARNING
Always switch OFF the emulator product and the user system
before connecting or disconnecting any CABLES except for
the USB interface cable. Failure to do so will result in a FIRE
HAZARD and will damage the user system and the emulator
product or will result in PERSONAL INJURY.
The USER PROGRAM will be LOST.
21