Renesas Emulator System E8 - Manual (Page 158)

⎯ MEMORY_FILL command
The [Format] specification in the [Copy Memory] dialog box is ignored. Memory is copied
in a byte unit.
17. Note on Using the [Run Program] Dialog Box
When [Run...] is selected from the [Debug] menu to specify the stop address, there is the
following note:
⎯ When the breakpoint that has been set as Disable is specified as the stop address, note that
the breakpoint becomes Enable when the user program stops.
18 [Stack Trace] window
When using the NC30WA or NC8C, if parameters and local variables of a function are
referred in the call stack window and one or more parameters are on a register, the register
parameters may be interchanged with the local variables. However, the correct values are
displayed.
19. Memory Access during User Program Execution
When a memory is accessed from the memory window, etc. during user program execution,
the user program is resumed after it has stopped in the E8 emulator to access the memory.
Therefore, realtime emulation cannot be performed
20 Internal Flash Memory
The emulator is also available as the programming tool for mass production.
However, the actual MCU, which has been used by connecting to the emulator, has been
programmed to the flash memory at emulation and stressed. Do not use the MCU that has been
used for debugging for the mass products.
21 Suspend during Emulator Use
[When using the E8 emulator software V.2.03 Release 00 or later]
The host computer cannot enter suspend mode.
[When using the E8 emulator software V.2.02 Release 00 or older]
Do not set the host computer to suspend mode while using the emulator. If the host computer
enters suspend mode, exit and restart the High-performance Embedded Workshop.
22 Verification of Memory
Use the FILE_VERIFY command to verify memory. Do not use [Verify Memory…] in the
[Debug] menu.
23 Overwrite of a File
In command line interface, a file that has the same name as the output file is overwritten
without asking the user.
140