Renesas Emulator System E8 - Manual (Page 25)

Section 2 E8 Emulator Functions
This section describes the emulator functions. They differ according to the device supported by the
emulator.
2.1 Overview
Table 2.1 gives a functional overview of the emulator.
Table 2.1 Emulator Functions
No. Item Function
1 User program execution
function
• Executes a program with the operating frequency within a
range guaranteed by devices.
• Reset
emulation
• Step
functions:
Single step (one step: one instruction)
Source-level step (one step: one source)
Step over (a break did not occur in a subroutine)
Step out (when the PC points to a location within a
subroutine, execution continues until it returns to the calling
function)
2 Reset function • Issues a reset from the High-performance Embedded
Workshop to the device during break.
3 Trace function
• Branch trace function incorporated in the device (four
branches)
The support of this function depends on a device.
4 Break functions
• Hardware break condition (one condition)
The support of this function depends on a device.
• PC break condition (255 points)
• Forced break function
• Address match break function
7