beautypg.com

Mastering effect, 217 adding effects – Roland X-6 User Manual

Page 217

background image

217

Adding Effects

This is a stereo compressor (limiter) that is applied to the final
output of the Fantom-X. It has independent high, mid, and low
ranges. Independently for the high-frequency, mid-frequency, and
low-frequency regions, this compresses any sounds that exceed the
specified level, making the volume more consistent. When mixing
down to MD, or DAT, or when you procedure your own original
audio CD, this lets you master at an optimized level.

*

Mastering effect settings apply to the entire Fantom-X. These settings
are not for individual patches or performances.

*

The mastering effect is applied to the sound that is output from the
OUTPUT A (MIX) jacks. It will not be applied to the sound that is
output from the OUTPUT B jacks.

fig.22-013_50

For details on these settings, refer to

“Making Effect Settings”

(p. 206)

ATTACK

Time from when the volume goes up the threshold level until the
compressor effect applies

Value:

0-100 ms

RELEASE

Time from when the volume falls below the threshold level until the
compressor effect no longer applies

Value:

50-5000 ms

THRESHOLD

Volume level at which compression begins

Value:

-36-0 dB

RATIO

Compression ratio

Value:

1.00:1-INF:1 (INF: infinity)

LEVEL

Output volume

Value:

0-24 dB

Split Frequency High

Frequency at which the high-frequency (HI) and mid-frequency
(MID) bands are split

Value:

2000-8000 Hz

Split Frequency Low

Frequency at which the low-frequency (LO) and mid-frequency
(MID) bands are split

Value:

200-800 Hz

Mastering Effect

Function Buttons

Explanation

[F1]–[F5]

Recall preset settings for each type.

[F6 (User)]

Recall saved user settings.

[F7 (System Write)]

Save the current settings as user set-
tings. Only one set of user settings
can be saved.

[F8 (Effect Sw]

You can press this to open the Effect
Sw window and turn each effect
on/off. Turn [F6 (Mastering Sw)]
on/off to hear the result of the mas-
tering effect.

About THRESHOLD and RATIO

As shown in the diagram below, these parameters determine
how the volume is to be compressed.

fig.22-014.e

1:1

2:1

4:1

INF:1

THRESHOLD

Input Level

Output Le

v

e

l

RATIO

Fantom-X678_r_e.book 217 ページ 2007年3月20日 火曜日 午前10時20分